To adjust the bike’s suspension setup, you should open all your damping settings. This means: The rebound – the red adjuster knob – needs to be turned counterclockwise as far as it will go. On a Simplon MTB, the adjustment range is illustrated with a plus and minus symbol. Then, it’s time to adjust the compression.
How do I make my mountain bike suspension softer?
If you need a harder or softer spring, buy a new coil spring. That’s it. Using a spring that’s too soft (ie. too low a air pressure) will result in suspension that wallows about too deep into its travel and bottoms out too easily.
Can you upgrade suspension on mountain bike?
Upgrading the suspension on your mountain bike is one of the best things you can do to breathe new life into your bike. … There are millions of bicycles out there in the world — and all sorts of exceptions to “common” — so please keep that in mind.
Can I put a bigger rear shock on my bike?
The longer the rear shock, the more oil will be available to absorb the shock better. In this scenario, it does make sense to buy a longer rear shock. There will be more oil and space to absorb a lot of the movement of the bike while riding.
Can I put a coil shock on my bike?
Coil shocks usually play best with bikes that a more progressive suspension leverage rate. Some bike manufacturers may recommend against using a coil shock due to a frame’s linear leverage rate or particular fitment issues.
How do you adjust a coil suspension?
The difference between the two measurements is sag.
- To increase sag, turn the preload adjuster counter-clockwise. …
- To decrease sag, turn the preload adjuster clockwise no more than two full turns. …
- To change to a higher or lower rate spring, see the Changing Coil Springs section below.
How much sag do you get from rear suspension?
For the rear shock – 20% – 30% sag is recommended. For the most part, this can be used across the board for trail bikes and downhill bikes. Again, keep in mind you may want more or less sag depending on your bike, weight, and riding preferences. For the front fork- 10% sag is recommended.